How To Remove Lawn Mower Blade Victa

This insures oil does not flow into the intake or exhaust and cause trouble later. Remove the spark plug boot and undo the 4 bolts that hold the cylinder head in place as seen in the video.

4lqmccenmu22xm

How to replace lawn mower blades on a ride-on mower.

How to remove lawn mower blade victa. Removing the blade holderhttpsyoutubedRid. This video is also associated with the followingOil change on mowerhttpsyoutubePyp965w7mmIVicta mower. To remove the blade you must turn the blades retaining bolt to the left or counterclockwise.

Set it to the lowest point it can go. Removing old lawn mower blades. Either remove the main securing bolt and remove bolts securing blades or remove blade bolts while still attached to the mower.

Best watched with closed captions in this episode we change a set of Victa Lawn Mower bladesand then we supercharge them and show you the differenceRela. Remove the mower deck. Remove the engine from the lawn mower click here for a tutorial.

Lower the mower deck. Either disconnect the fuel line and remove the top cover or empty fuel from the mower before turning it onto its side. Place the boss over the anvil and hit it with a hammer rotating the blade boss as you do so this should loosen it and allow it to be removed.

Disengage the blades and release the blade belt. The occasional oil change and air filter chang. Turn off and unplug the mower.

When looking at the blade boss you will notice on one side there is a hole fill this with WD-40. This Tutorial Demonstrates the process of replacing the blades on a victa lawn mower should be similar between models and brands Click Below For More Infoma. I removed the blade buy undoing the nut and it all came apart fine i put it back together and still the blade freely rotates and points to the ground when the mower is on its side.

They are hard to remove and you will undoubtably damage it during removal but. Rugged construction and simple operation. This video will show you how to tighten a blade carrier which has become looseClick Below For More InformationVisit our site for more tutorials Parts and.

Undo the decompressor using the appropriate spanner. Remove Spark Plug lead for safety reasons. Remove the muffler from the front of the engine by using a screwdriver to disconnect the 2 clips top and bottom holding it in place.

To avoid internal oil spillage in 4-stroke mowers ensure the spark plug faces upwards to avoid dousing it in fuel. Looking at the second blade that was firmly stuck pointing out at 90deg like i expected it to i cleaned away grass and with a small amount of pressure i could. Undo the two Phillips head screws that hold the carburetor manifold to the engine block.

Remove the key and unplug the spark plug for safety. Begin by removing the screwing holding the top cover unplug the fuel hose and remove the top cover altogether. The iconic Victa Utility mower remains one of the best of its type.

You need to heat the hub and strike it with a hammer in the same direction as removing the blade nut. Lift up the mower with the front wheels facing skyward. Ensure that the mower is drained or low on fuel and lawn mower oil to avoid spills.

You may need to tip your mower to remove or replace blades which can be done during a lawn mower service. Remove the blade carrier with blades attached by undoing the bolt in its center which holds it in place use the 24mm 1 inch socket. Ride-on mowers follow a similar process but require a few extra steps.

Before undoing the blade tip the mower on.

How To Sharpen Lawn Mower Blades The Home Depot