How To Remove Mower Blade Boss

Step 2 - Removing the Blade Before we start make sure you have enough room for when removing the blade - youll want to first tip the lawn mower carefully onto its side. BLADE BOSS FOR ROVER MOWERS.

How To Sharpen A Lawnmower Blade Any Make Or Model Briggs And Stratton Etc Youtube

When looking at the blade boss you will notice on one side there is a hole fill this with WD-40.

How to remove mower blade boss. Ensure that the diameter of the boltmetal doesnt exceed the size of the hole it needs to sit inside. Align the two jaw pullers with the end of the boltmetal and hook the pullers onto the boss. It walks you through the whole process inspecting blade and blade boss removing blade sharpening balancing refitting and torqueing the blade bolt to spec.

At Blade Boss LLC we have combined 26 years of brand e-commerce and sharpening know-how to create a service we hope you cant live without. LAWN MOWER DISC BLADE BOSS FOR ROVER MOWERS A01021. The other trick is to clean the shaft above the boss lube it well then drift the boss up clean the shaft where the boss was then slide it off.

Use a puller bearing on the temporarily loosly re-installed blade bolt to pull it off. You can use a piece of wood like a small 2x4 to block the blade from turning then remove bolt 505 with a socket and ratchet. Place the boss over the anvil and hit it with a hammer rotating the blade boss as you do so this should loosen it.

You need to heat the hub and strike it with a hammer in the same direction as removing the blade nut. Well thats what ive found. Remove the engine from the lawn mower click here for a tutorial.

This can work well. This video demonstrates how to easily remove the blade bossadapter from a lawn mower. If you need video help check out Replacing mower blade in the mower repair video library.

Before undoing the blade tip the mower on. Click Below For More InformationVisit our site for more tutorials Pa. If it will not remove easily by simply puuling with both hands then screw in the blade bolt leaving a gap between the boss and the head of the bolt.

After its off DISCONNECT SPARK PLUG then have someone pull in the engine brake control and rotate the engine sing the start rope. A01021 with 78 crankshafts. With a hammer in one hand and the other pulling behind the blade boss gently tap the head of the bolt until it releases.

Place boltpiece of metal into the hole in the middle of the boss. If the crank rotates off-centre the engine is scrap. Once the bolt washers and blade are removed the blade boss will slide straight down the shaft for removal.

They are hard to remove and you will undoubtably damage it during removal but. To remove the blade you must turn the blades retaining bolt to the left or counterclockwise. FITS 18 19 ROVER MOWERS.

From here you can then begin the removal of the old blade. The blade boss is easy at least in theory. Whether you are a dog groomer barber hair stylist or sheep shearer the quality of your craft and comfort of your clients comes down to technique and the sharpness of your clipper trimmer and scissor.

Time wise its easier to use a puller.

Allis Chalmers 916h Riding Lawn Mowers Garden Tractor Tractors