How To Remove Old Toilet Seat Plastic Bolts

Use your fingers or a screwdriver to pry up the plastic housing to uncover the bolt. After a few moves the rusted bolts will start breaking.

7 Easy Steps To Replace A Toilet Seat

Give a gentle force so that the bolts cut faster.

How to remove old toilet seat plastic bolts. That leaves just one option. Clean toilet seat If your toilet has hidden fixings. The plastic bolts are hidden under a small plastic housing at the top of the seat.

Put on goggles to protect your eyes. Start from the base of the bolt where the washer is attached to the bolt. When it comes to removing toilet seats the big gun is a drill with a 14-inch drill bit.

Cut through the bolt along with the hinges connected to the toilet seat. But most old toilet seats are held in place with metal bolts that tend to rust in place over time making them impossible to remove with a wrench. Loosen the nuts from the bolts using your hands or an adjustable wrench.

Remove caps and slide seat off hinges If your toilet has a quick-release. Start by locating the seat bolts at the back of the bowl. First take a look at the bolts that secure the seat.

Removing the old seat often the bol. Use steady pressure to break the bolt and nut as you drill. Another option is to drill out the bolts.

Simply pry open the cover behind the seat to expose the bolts head. This vid shows how to remove a stripped expansion bolt with rubber gasket from the base of a Toto toilet. The plastic fasteners on modern toilet seats dont corrode.

Removing a Plastic Nut From a Toilet Seat Hinge. Installing a new toilet seat is a simple 2 minute job getting the old urine rusted nuts off can be a frustrating ordeal. First protect the top of the toilet with strips of duct tape or thin cardboard.

Then insert the bit into the bottom of a stuck metal nut that you cant turn at the point at which it meets the bolt. Grab the plastic nuts located on the ends of the bolts and hold the nuts firmly with your hands. Many new toilet seats are attached to the toilet bowl with two plastic bolts and nuts.

The plastic is relatively soft so go easy until you get a grove and then apply more pressure and eventually you will break through. Then use a close-quarter hacksaw like the one shown above. Remove bolt covers if necessary.

Removing a Toilet Seat at a Glance. Unscrew the bolt with a pliers or a screwdriver while you hold the nut underneath with the pliers. Open the toilet seat completely and cover the top of the toilet in front of the bolts with duct tape or pieces of cardboard.

Pliers are a good way to get the job done but if the bolts are too tight use a thin drill with a thickness of about 116 inch. Move the cutter frequently and cut the whole bolt and remove it from the toilet seat. Repeat the process on the other plastic cover.

Hold a close-quarter hacksaw along the side of the bolt and face it. Cut the seat off with a hacksaw. Loosen nuts and bolts Step 4.

You could also score it with a utility knife with a new sharp blade. Drill a hole straight up through the inside edge of the nut. Tape seat and cover together Step 2.

If the bolts or nuts are plastic they cant corrode and will come off easily. Flathead or Phillips screwdriver socket wrench pliers gloves duct tape penetrating oil Step 1. Pop off protective caps Step 3.

Then use a screwdriver to pry apart and you should be able. Place the tip of a screwdriver into the slot of one of the two plastic covers behind the toilet seat and gently pry up to flip the cover backward.

How To Remove Toilet Seat Step By Step Bathroompicks Bathroompicks