Remove Jumper Cables While Car Is Running

Put your penis in the fan belt. Some batteries may be covered with plastic hoods you need to remove these in order to connect the cables for the jump.

Step By Step Guide On How To Jump Start Your Car With Jumper Cables

Connect the Cables.

Remove jumper cables while car is running. No jump box cables or charger around so took battery from late 70s early 80s ford pickup hooked up to mine started no problem then removed truck battery and connected mine while running. Then you start the dead car. Then remove the positive cable from the car with the good battery dont touch a grounded part of either car with the clamp of the positive cable.

Once you remove the jumpers if a car shuts down immediately its the alternator not the battery battery is primarily for starting the car not keeping it running. When it starts you should let it run for a while so that it can charge up the dead battery. Turn the engine off in the car with the good battery.

Remember to thank the person who helped jumpstart your car. Disconnecting the Jumper Cables. If the batteries are covered by plastic hoods remove the hoods so the battery posts are exposed.

It is advisable to take the cables from the car that was jump starting the dead battery first. When the car has recharged you should remove the jumper cables and be cautious so as to prevent the cables from touching each other. Carefully install your new battery and tighten the terminals.

BEFORE taking the jumper cables off of course. Park the cars close enough for the cables to reach but they should not touch. If they do not match serious damage can occur to both vehicles.

No power windows no radio no brake lights no rear running lights. Then remove the red positive cable 1st then the black from the now running car and then from the helping car. First remove the negative cable from the car you jumped then the negative cable from the car with the good battery.

Turn the key in the dead car to start and it should fire right up. Begin by parking the vehicle with the good battery next to the car with the dead battery. Now no dash lights blinkers all blink fast now front and rear.

Open both cars hoods and locate the batteries within both of them. Red 1st then black. The batteries have both positive and negative - posts.

With jumper cables still hooked to your car start your engine then remove the jumper cables. Your car is running but your job isnt over. Remove the other black clamp from the negative terminal of the good battery.

After several minutes you can remove the jumper cables in the following order. Open the hoods of both cars and locate their batteries. The car with the good battery needs to be parked closely to the car with the dead battery.

If the vehicle starts remove the cables in the reverse order they were put on being careful not to let them touch. Once your dead car has started and is running immediately disconnect the jumper cables in the reverse order. You could have a faulty alternator.

Disconnecting the jumper cables doesnt need to happen in any specific order but be sure you dont let the red and black cables touch each other at the end when they are still connected to one battery. Then put the other end of the cables on the dead car. The power surge generated by the jumpstart can short them out.

Once you get your car running. Red 1st then black. Remove the red clamp from your batterys positive terminal.

Unplug any accessories like cell phone chargers. Disconnect the cables in the reverse order. You have the good car running and attach the jumpers to it.

Remove the black clamp from the grounded surface of your vehicle. You can disconnect the jumper cables right away.

How To Jump A Car Digital Trends